Università degli studi di Modena e Reggio Emilia

The combined use of Uncrewed Aerial Vehicles (UAVs) with an integrated Real Time Kinematic (RTK) Global Navigation Satellite System (GNSS) module and an external GNSS base station allows photogrammetric surveys with centimeter accuracy to be obtained without the use of ground control points. This greatly reduces acquisition and processing time, making it possible to perform rapid monitoring of landslides by installing permanent and clearly recognizable optical targets on the ground. In this contribution, we show the results obtained in the Ca’ Lita landslide (Northern Apennines, Italy) by performing multi-temporal RTK-aided UAV surveys. The landslide is a large-scale roto-translational rockslide evolving downslope into an earthslide–earthflow. The test area extends 60 × 103 m2 in the upper track zone, which has recently experienced two major reactivations in May 2022 and March 2023. A catastrophic event took place in May 2023, but it goes beyond the purpose of the present study. A total of eight UAV surveys were carried out from October 2020 to March 2023. A total of eight targets were installed transversally to the movement direction. The results, in the active portion of the landslide, show that between October 2020 and March 2023, the planimetric displacement of targets ranged from 0.09 m (in the lateral zone) to 71.61 m (in the central zone). The vertical displacement values ranged from −2.05 to 5.94 m, respectively. The estimated positioning errors are 0.01 (planimetric) and 0.03 m (vertical). The validation, performed by using data from a permanent GNSS receiver, shows maximum differences of 0.18 m (planimetric) and 0.21 m (vertical). These results, together with the rapidity of image acquisition and data processing, highlight the advantages of using this rapid method to follow the evolution of relatively rapid landslides such as the Ca’ Lita landslide.

Large-scale slow-moving deep-seated landslides are complex and potentially highly damaging phenomena. The detection of their dynamics in terms of displacement rate distribution is therefore a key point to achieve a better understanding of their behavior and support risk management. Due to their large dimensions, ranging from 1.5 to almost 4 km(2), in situ monitoring is generally integrated using satellite and airborne remote sensing techniques. In the framework of the EFRE-FESR SoLoMon project, three test-sites located in the Autonomous Province of Bolzano (Italy) were selected for testing the possibility of retrieving significant slope displacement data from the analysis of multi-temporal airborne optic and light detection and ranging (LiDAR) surveys with digital image correlation (DIC) algorithms such as normalized cross-correlation (NCC) and phase correlation (PC). The test-sites were selected for a number of reasons: they are relevant in terms of hazard and risk; they are representative of different type of slope movements (earth-slides, deep seated gravitational slope Deformation and rockslides), and different rates of displacement (from few cm/years to some m/years); and they have been mapped and monitored with ground-based systems for many years (DIC results can be validated both qualitatively and quantitatively). Specifically, NCC and PC algorithms were applied to high-resolution (5 to 25 cm/px) airborne optic and LiDAR-derived datasets (such as hillshade and slope maps computed from digital terrain models) acquired during the 2019-2021 period. Qualitative and quantitative validation was performed based on periodic GNSS surveys as well as on manual homologous point tracking. The displacement maps highlight that both DIC algorithms succeed in identifying and quantifying slope movements of multi-pixel magnitude in non-densely vegetated areas, while they struggle to quantify displacement patterns in areas characterized by movements of sub-pixel magnitude, especially if densely vegetated. Nonetheless, in all three landslides, they proved to be able to differentiate stable and active parts at the slope scale, thus representing a useful integration of punctual ground-based monitoring systems.